American-sanders FloorCrafter Belt Sander User Manual download pdf (Page 7)

ENGLISH

Clarke

American Sanders Operator's Manual (EN) - Floorcrafter - 7 -

Figure 4

Figure 3

Figure 2

AB B A

How to Transport the Machine

WARNING: The machine is heavy. Remove the motor

from the machine before transporting. Get

help loading the machine and motor. Use

proper lifting techniques.

Transporting the Machine - Using the Dolly Cart

CAUTION: When deploying the dolly, the drum will

contact the oor or ground over which the

machine is resting. Care should be taken

to avoid surfaces which might damage or

contaminate the drum.

CAUTION: While transporting using the dolly, abrupt

changes in the direction of travel or the

surface over which the machine is being

transported could cause the machine to tip

over. Also, the machine is more likely to

tip over when transporting across inclined

surfaces.

Attach the dolly to the rear of the machine as follows:

1. Open the quick release levers (2A) and unscrew the adjustment

nuts (2B) to allow installation of the dolly. (See gure 2)

2. Insert the quick release skewers into the dolly brackets and

immediately tighten the adjustment nuts until the dolly mechanism

will just swing free.

Deploy the dolly under the machine as follows:

1. With the dolly mechanism in place as described above, tip the

machine by lifting up on the operators handle to raise the rear of

the machine off the oor/ground until the dolly swings under the

machine. (See gure 3)

2. Hold the dolly in position using your foot and allow the machine to

tip back and rest on the dolly wheels. (See gure 4)

3. Tip the machine back on all four wheels and close the quick

release levers for transport. Some adjustment of the quick

release skewers may be necessary to allow the levers to be

tightened securely.

Removing/Storing the dolly:

The dolly can be stored on the machine in the “UP” position or it can

be removed and stored separately.

1. Open the quick release levers to loosen the dolly.

2. Lift up on the operators handle to tip the machine forward.

3. Swing the dolly out from under the machine and lower the

machine until it rests on its own wheels.

CAUTION: Be careful when lowering the machine.

The dolly will swing back toward the

operator as the machine is lowered.

1 2 3 4 5 6 7 8 9 10 11 12 ... 75 76

Comments to this Manuals

No comments

American-sanders FloorCrafter Belt Sander User Manual Page 7

Comments to this Manuals

Related products and manuals for Vacuums American-sanders FloorCrafter Belt Sander